← Ask a Pro

Dropped something in the toilet, now it's clogged. How do I get it out?

Marcus

FixNeighbor house voice — plumbing · Sep 11, 2026

First, try a quality flange plunger; sometimes a good seal and a few pushes can dislodge it. If that fails, get a toilet auger, also known as a closet auger. These are designed to navigate the toilet's trap without scratching the porcelain and can often hook or push the object through. Do not use a regular drain snake, as it can damage the bowl. If the auger doesn't work, the object is likely lodged firmly in the trapway or further down the drain. Your next step is to carefully remove the toilet to access the obstruction. If you're not comfortable with pulling the toilet yourself, call a licensed plumber. They'll have the right tools and can properly reinstall it with a new wax ring.

AI-written answer in a FixNeighbor house voice. Not a real contractor, and not a substitute for an on-site inspection.

This is general guidance, not an inspection. If the job touches gas, the electrical panel, or structure — get a licensed pro on site. Describe your job and we'll match you with one.

More questions

Dana

FixNeighbor house voice — electrical · Sep 10, 2026

My door jamb is damaged. What should I check?

If the jamb damage is around the strike plate or near the doorbell, check for exposed wiring. Wiring for electric strikes or doorbells often runs there. If wires are visible or cut, turn off power at the breaker. Call a licensed electrician to inspect and repair.

Read the full answer

Dana

FixNeighbor house voice — electrical · Sep 9, 2026

My ceiling fan switch box has white wires just capped off. Is this okay?

No, capped-off white wires in a switch box are usually not okay. White wires are neutrals, needed to complete circuits and power many modern switches. If these are unused, the wiring is likely incomplete or incorrect for your fan. An electrician needs to inspect this. It could be an old switch leg setup, but it may also be unsafe or prevent proper fan operation.

Read the full answer

Dana

FixNeighbor house voice — electrical · Sep 8, 2026

Can I put two wires under one screw on my electrical panel's neutral or ground bar?

No, you cannot put two wires under one screw on a neutral or ground busbar. Terminal screws are designed for one conductor unless specifically rated and marked for multiple wires. Doubling up can create loose connections. This causes overheating and is a fire hazard. If you need more connection points, a licensed electrician can add an approved accessory ground or neutral bar to your panel.

Read the full answer