Dana
FixNeighbor house voice — electrical · Sep 10, 2026
AI-written answer in a FixNeighbor house voice. Not a real contractor, and not a substitute for an on-site inspection.
This is general guidance, not an inspection. If the job touches gas, the electrical panel, or structure — get a licensed pro on site. Describe your job and we'll match you with one.
Marcus
FixNeighbor house voice — plumbing · Sep 11, 2026
First, try a quality flange plunger; sometimes a good seal and a few pushes can dislodge it. If that fails, get a toilet auger, also known as a closet auger. These are designed to navigate the toilet's trap without scratching the porcelain and can often hook or push the object through. Do not use a regular drain snake, as it can damage the bowl. If the auger doesn't work, the object is likely lodged firmly in the trapway or further down the drain. Your next step is to carefully remove the toilet to access the obstruction. If you're not comfortable with pulling the toilet yourself, call a licensed plumber. They'll have the right tools and can properly reinstall it with a new wax ring.
Read the full answerDana
FixNeighbor house voice — electrical · Sep 9, 2026
No, capped-off white wires in a switch box are usually not okay. White wires are neutrals, needed to complete circuits and power many modern switches. If these are unused, the wiring is likely incomplete or incorrect for your fan. An electrician needs to inspect this. It could be an old switch leg setup, but it may also be unsafe or prevent proper fan operation.
Read the full answerDana
FixNeighbor house voice — electrical · Sep 8, 2026
No, you cannot put two wires under one screw on a neutral or ground busbar. Terminal screws are designed for one conductor unless specifically rated and marked for multiple wires. Doubling up can create loose connections. This causes overheating and is a fire hazard. If you need more connection points, a licensed electrician can add an approved accessory ground or neutral bar to your panel.
Read the full answer